SG Security Communications MLR2-E Manual de usuario Pagina 7

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 16
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 6
6
MLR2-DG
MULTI-LINE DIGITAL RECEIVER
MULTI-LINE DIGITAL RECEIVER
Liquid Crystal Display: Shows incoming data, programming information, and so on. The
LCD is backlit to improve visibility in low light.
AUDIO: This LED is illuminated when the receiver is in Audio Mode. It indicates
that listen-in or two-way audio is in use. It automatically shuts off at
the end of the timed period or when the [CANCEL] button is pressed.
LINE FAULT: Illuminates if the Phone Line is disconnected and turns off automatically
when the line is restored.
MESSAGE ERROR: Illuminates when faulty data is received (round pair not matching, incorrect
parity, etc.). Press the [ACK] button in Manual Mode to clear the
error.
ACK/FUNCTION Button: When in emergency Manual Mode, press this button to acknowledge
an alarm. In the normal mode, this button provides access to the Line
Card menu.
ALARM: The Alarm LED is located inside the [ACK] button. It will flash if an
Alarm is received and it turns off when the alarm is successfully sent
to the CPM2, or acknowledged by the operator.
TROUBLE: Illuminates when the Line Card is shut down by operator command or
when the CPM2 is in failure or absent. The LED is shut off when the
trouble condition is restored.
CANCEL/SELECT Button: When the Line Card is on line, press this button to stop the communication
and return to off line mode. In the Stand-By Mode, pressing [CANCEL]
has no effect. When in Menu Display Mode, this button is used to
select the menu choice. Once a menu is selected, pressing the [CANCEL]
button scrolls down to the next feature.
ON LINE: Illuminates when the Line Card is on line. The LED is off when the unit
is in the Stand-By Mode.
WATCHDOG: Flashes every 4 seconds to indicate Line Card operation is being
monitored.
SWITCHES AND LIGHTS ON THE SG-DRL2A
Each module of SG-DRL2A has 2 line cards. The LEDs and push button switches on the
left side and the upper LCD are for Line Card 1. The LEDs and push button switches on
the right side and the lower LCD are for Line Card 2.
Vista de pagina 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Comentarios a estos manuales

Sin comentarios